096 Transmission

Shifter And Related Components:

CAUTION:
- Before working on a running engine, position the selector lever at "P" and apply the parking brake.
- Before engaging a selector position from position "P" after starting the engine. the brake pedal must be applied.

1 - Transmission
2 - Lever for selector cable
3 - Bracket for selector cable
4 - Washer
5 - Selector lever cable
- Do not bend or kink
- Grease cable ends lightly before installing.
- Check that protective sleeve is located properly.
- Secure selector cable with clip.
- Adjusting: place selector lever at "P" loosen screw of gear lever shaft, set gear lever at "P" (detent must engage parking lock), tighten screw to 20 Nm (14 ft lb).

Note:
- The Front Exhaust Pipe And Deflector Must Be Removed When Replacing The Selector Lever Cable.

6 - Shoulder screw - 25 Nm (18 ft lb)
7 - Clip for selector lever cable
8 - 25 Nm (18 ft lb)
9 - 15 Nm (11 ft lb)
10 -Selector support
11 -Gasket always replace
12 -Boot install in support before installing cable.
13 -10 Nm (7 ft lb)
14 -Bushing
15 -Lock lever locks selector lever in "N" or "P"
16 -Spring
17 -Selector lever
- with locking segment and pressure rod
- replace complete assembly only
- assemble before installing
18 -Bushing
19 -Bolt
20 -Clip install after inserting selector cable
21 -Bulb holder
22 -Sleeve
23 -Cover
24 -Program switch - E122
25 -Handle
26 -Set screw install with locking fluid
27 -Selector lever lock solenoid
- to adjust or replace switch, detent segment must be removed
28 -3 Nm (27 in. lb or 31 cm kg) install with locking fluid
29 -Wiring harness for illumination and selector lock solenoid - N110