Checking Windshield Wiper/Washer System

Use test system VAG 1466 for troubleshooting.

Test Conditions:
^ Fuse no.5 (15 A) OK
^ Windshield wiper in end position

Preparation for Troubleshooting
- Remove washer/wiper intermittent relay J31 (production control number 99) from relay location 8.
- Remove rear window wiper/washer relay J30 (production control number 72) from relay location 2. Only Variant (station wagon).
- Insert test adapter VAG 1466/5 into relay location 8.
- Connect VAG 1466 to test adapter.

Troubleshooting - Checking Windshield Wiper/Washer System (Part 1 Of 2):

Troubleshooting - Checking Windshield Wiper/Washer System (Part 2 Of 2):

Troubleshooting Procedure
- Perform test steps according to table.
- If specified value/test result is obtained, proceed to next step (test result OK).
- If specified value/test result is not obtained, use table for troubleshooting and repair.
- Use valid wiring diagram for wire testing.
- Disconnect test leads after each step.

NOTE:
- If malfunction has not been eliminated after performing steps 1 to 8, replace washer/wiper intermittent relay J31.
- After repairing malfunction, perform functional test of windshield wiper/washer system.