Input/Output Shaft, Differential and Shift Forks Remove/Install

COMPONENT NOTES AND INFORMATION
1 Differential
- Disassembling and assembling, refer to Overhaul. Overhaul
2 Sealing ring
- Quantity: 4
- Always replace
3 Output shaft
- Disassembling and assembling, refer to Overhaul.
4 Reverse idler shaft support
- Disassembling and assembling, refer to Overhaul.
5 Reverse idler shaft
- Disassembling and assembling, refer to Overhaul.
6 Input shaft
- Disassembling and assembling, refer to Overhaul.
7 Shift forks
- Disassembling and assembling, refer to Overhaul.
8 Torx socket-head bolt
- Tightening torque: 25 Nm (18 ft lb)
9 Reverse gear shift fork
- Disassembling and assembling, refer to Overhaul. Service and Repair
- Installation position, refer to Disassembly/Assembly Procedure
10 Clutch housing
- Servicing, refer to Overhaul.
11 Hex nut
- Tightening torque: 25 Nm (18 ft lb), plus an additional 1/4-turn (90°)
- Four nuts for bearing mount
12 Axle flange shaft
13 Circlip
- Always replace
- Removing and installing, refer to Disassembly/Assembly Procedure
14 Axle flange shaft with spring
15 Cone-head bolt
- Installed in transmissions with springs behind axle flange shafts, refer to item -14-