Without Air Conditioning

CAUTION: Before working on electrical system, obtain radio code and disconnect battery Ground (GND) strap.

NOTE: All available procedures for servicing components are not necessarily in this article alone. If the information needed is not found in this article, try looking for information under specific component.




1 - Left plenum cover
2 - Connecting clip
3 - Right Plenum Cover
Exploded Views
4 - Air intake adapter
- Dust and pollen filter (if equipped).
5 - Side window air outlet
6 - Right air outlet
- Replacing: if air guide (under instrument panel) already has seal installed, remove glued on seal from replacement part before installing.
7 - Center air outlet
- Replacing: if air guide (under instrument panel) already has seal installed, remove glued on seal from replacement part before installing.
8 - Trim cover
9 - Nut
10 - Fresh air blower series
Resistance with fuse -N24-
11 - Fresh air blower -V2-
12 - Trim plate
13 - Self-tapping screw
14 - Footwell air outlet
- To remove, first remove center console
15 - Rear footwell air duct connector, right
16 - Self-tapping screw
17 - Self-tapping screw
18 - Rear footwell air duct, right
19 - Rear footwell air duct, left
20 - Rear footwell air duct connector, left
21 - Clip
22 - Control cables
23 - Fresh air/heating controls
24 - Heater box/evaporator housing
- To remove: Remove instrument panel.
- Remove housing support bracket.
- Disconnect heater core hoses and plug heater core outlets (to prevent coolant spills).
- Remove heater box/evaporator housing.
25 - Heater core
- Replacing: remove instrument panel and heater box/evaporator housing
26 - Left air outlet
- Replacing: if air guide (under instrument panel) already has seal installed, remove glued on seal from replacement part before installing.
27 - Side window air outlet
28 - Instrument panel
- Do not disassemble further than shown