Planet Carrier and Trans. Housing With Input Gear and Cover

NOTE: Refer to Planetary Gearbox Disassembly/Assembly

COMPONENT NOTES AND INFORMATION
1 Planet carrier
- Adjusting. Adjustments
2 O-ring
- Always replace
- Insert in planet carrier
3 Axial needle bearing washer
4 Axial needle bearing
5 Axial needle bearing washer
- Install smooth side in input gear
6 Transmission housing with input gear installed
7 Input gear
- Do not remove to disassemble planetary gearbox
- Removing and installing input gear or axial needle bearing for planet carriers, refer to Input Gear. Service and Repair
8 Planet carrier shim
- Determining thickness, refer to Adjusting planet carrier. Adjustments
9 Washer
10 Bolt
- Tighten to: 30 Nm (22 ft lb)
- For small input shaft
11 Spacer bushing
- Clip qty. 7 into gasket
12 Gasket
- Always replace
13 Cover
14 Bolt
- Tighten to: 8 Nm (70 inch lb)