Sunroof Servicing Assembly Overview

1. Glass panel for sunroof

^ Single pane green safety glass
^ Removing Removal
^ Installing Installation
^ Adjusting Sunroof Panel Height

2. Panel seal

^ Seal joint is in center of right side section
^ Use water to lubricate panel seal clamping channel before installing
^ Adjusting Panel Seal

3. Trim frame

^ Removing Removal
^ Different versions

Note: Due to a running change in production, on some vehicles the cable drive -12- must also be replaced when replacing the sliding headliner -4-.

4 . Headliner To 08.94

^ Removing
^ Installing

5. Headliner From 09.94

^ Removing
^ Installing

6. Carrier unit

^ Removing Removal

^ Installing Installation

Carrier unit consists of the following parts:

^ U frame with guide channels (if required, guide channels are to be lubricated with special grease G 000 450 02 only, to ensure proper operation. Multi-purpose grease must not be used under any circumstances)
^ Rear guides with cables
^ Front guides

7. Hex key for emergency operation

^ Clipped onto cable driver

8. Wind deflector

^ Removing: Open glass panel and remove screws -10-

9. Threaded fitting

^ Thread must be at an angle toward rear

10. Screw

^ For wind deflector -8-

11. Countersunk self-locking screws

^ Always replace
^ 3 Nm (27 in lb)

12. Cable drive (electric)

^ Sunroof motor
^ Power sunroof control module -J245-
^ Checking "0" position Cable Drive "0" Position Checking

13. Locating hooks

14. Locating hook spring

15. Torx� screw

^ Torx� T25
^ 6 Nm (53 in. lb)

16. Adjusting plate

17. Water drain hose

^ Cleaning Cleaning Drain Hoses