Cruise Control System Checking

CRUISE CONTROL SYSTEM (MANUAL AND AUTOM. TRANSM.), CHECKING

Required for troubleshooting:
- VAG 1466 tester

Prerequisite:
- S14 OK!


CAUTION: DO NOT damage, enlarge or bend connector terminals or cavities by forcing probes into them when performing electrical checks. Always use connector test kit VW 1594 to make the necessary electrical connections.


Preparation:
- Remove Cruise Control Module (J213), located behind left side of instrument panel, behind light switch
- Insert test adaptor VAG 1466/8 into harness connector
- Connect adaptor to VAG 1466

Troubleshooting procedure:
- Perform test steps in numerical sequence according to table.
- If specified value/test result is obtained, proceed to next step (test result OK !)
- It specified value/test result is not obtained, use table for troubleshooting and repair
- Use valid wiring diagram for wire testing
- Disconnect test leads after each step

If malfunction has not been eliminated after performing all steps, replace cruise control, control module (J213).

After repairing malfunction, check cruise control system for proper operation

���Q:

Possible causes if specified value / test result is not obtained:

�: