Oil Pump: Service and Repair

NOTE: During removal and installation procedures, refer to the component location illustration and component notes.




Lubrication system, components

9- 20 Nm (15ft lb)

16- Oil pump cover with pressure relief valve
• Opening pressure: 5.7-6.7 bar (82.5-97 psi)

17- 10 Nm (7 ft lb)

18- 20 Nm (15 ft lb)
• Loosen or tighten bolts on flywheel side with tool 3185

19- Oil drain plug
• 30 Nm (22 ft lb)

20- Seal
• Always replace

21- Oil pan
• Clean mating surface before assembly

22- Suction line
• Clean screen if dirty

23- Baffle
• To remove, remove oil pump cover or suction line

24- Gasket
• Always replace Gasket with baffle plate (where applicable):
• Replace if damaged
• To remove, remove oil pump cover