Radiator Hose: Service and Repair

LEGEND
1 To Upper Radiator
2 O-ring
3 Coolant (Water) Pump
4 Clip
5 Engine Coolant Temperature (ECT) Sensor
6 From Expansion Tank
7 Connector Flange
8 To Heater Core
9 From Expansion Tank
10 Bolt
11 Bracket
12 From Heater Core
13 From Expansion Tank (Manual Trans.) Or ATF Cooler (Automatic Trans.)
14 Coolant Pipe
15 Oil Cooler
16 To Lower Radiator
17 Studs and Bolts
18 Alternator Bracket
19 Nut
20 Poly-Ribbed Drive Belt

NOTE: During removal and installation procedures, refer to the component location illustration above and component notes below.

COMPONENT NOTES
O-ring (2)
- Always replace.

Coolant (Water) Pump (3)
- Refer to Water Pump.

Engine Coolant Temperature (ECT) Sensor (4)
- With Engine Coolant Temperature Sensor (G2).

Hose From Expansion Tank (1)
- For vehicles with automatic transmission.

Bolt (10)
- Tighten to: 10 Nm (7 ft. lbs.).

Studs and Bolts (17)
- Tighten in two stages:
- 1st stage: 20 Nm (15 ft. lbs.).
- 2nd stage: turn an additional 90° (1/4 turn).

Nut (19)
- Tighten to: 30 Nm (22 ft. lbs.).