Output Shaft, M/T

1 - Hex nut -- quantity: 4
^ Tightening torque for bearing support (9): 25 Nm (18 ft lb), plus additional 90° (1/4-turn)
2 - Clutch housing
3 - Shim
4 - Small tapered roller bearing outer race
^ Bearing must be replaced as a set with large tapered roller bearing (7)
5 - Small tapered roller bearing inner race
6 - Output shaft
^ Paired with final drive gear (differential ring gear); always replace as a set
7 - Large tapered roller bearing inner race
^ Bearing must be replaced as a set with small tapered roller bearing (4)
8 - Sealing rings -- quantity: 4
^ Install on bolts for bearing support (9)
9 - Bearing support -- with large tapered roller bearing outer race and bolts
^ Only replace outer race together with large tapered roller bearing and bearing support
10 - Thrust washer
^ Shoulder on thrust washer faces tapered roller bearing
11 - 1st gear
12 - Needle roller bearing for 1st gear
13 - 1st gear synchronizer ring (synchro-ring)
14 - 1st/2nd gear operating sleeve with synchronizer hub (synchro-hub)
15 - Circlip
16 - 2nd gear synchronizer ring (synchro-ring)
17 - 2nd gear synchronizer outer ring
18 - 2nd gear synchronizer inner ring
19 - 2nd gear
20 - Needle roller bearing for 2nd gear
21 - Thrust Washer
22 - Sleeve for 3rd gear (3GR) needle roller bearing
23 - Needle roller bearing for 3rd gear (3GR)
24 - 3rd gear (3GR)
25 - 3rd gear (3GR) synchronizer ring (synchro-ring)
26 - Operating sleeve with synchronizer hub (synchro-hub)
^ For 3rd gear (3GR) and 4th gear (4GR)
^ Press off with 2nd gear and 3rd gear
27 - Sleeve for needle roller bearing
28 - Needle roller bearing for 4th gear (4GR)
29 - 4th gear (4GR) synchronizer ring (synchro-ring)
30 - 4th gear (4GR)
31 - Thrust washer
32 - Needle roller bearing for output shaft
33 - Transmission housing
34 - Sleeve for output shaft needle roller bearing
35 - 5th gear
36 - Belleville spring washer
37 - Torx(r) socket-head bolt M10
^ Tightening torque: 8O Nm (59 ft lb)