With Manufacturer Scan Tool

Erase DTC Memory (Function 05)


NOTE: The VAG 1552 Mobile Scan Tool (ST) can be used instead of the VAG 1551 Scan Tool (ST), however a print-out is not possible.

- Connect VAG 1551 scan tool. Refer to "Selectable Functions When Using VAG 1551", under "Restraint Systems", Scan Tool Connecting and Initial Checks
- Initiate On Board Diagnostic (OBD). On Board Diagnostic (OBD), Initiating Program

Requirements

- All malfunctions repaired
- Functional check completed
- DTC memory checked again

Indicated on display


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -5- to select "Erase DTC Memory" function 05.

Indicated on display


Rapid data transfer Q
05 - Erase DTC Memory


- Press -Q- button to confirm input.

Indicated on display


Rapid data transfer ->
DTC Memory is erased!


DTC memory is now erased.

- press -> button.

Indicated on display


Rapid data transfer HELP
Select function XX


NOTE:
- This message indicates an error in the test sequence.


Attention! ->
DTC Memory was not interrogated


- Adhere exactly to the test sequence: first check DTC memory, and if necessary, repair malfunctions, then erase DTC memory.

- Press buttons -0- and -6- to select "End Output" function 06.

Indicated on display


Rapid data transfer Q
06 - End Output


- Press -Q- button to confirm input.

Indicated on display


Rapid data transfer HELP
Insert address word XX


- Switch ignition off.
- Disconnect scan tool from Data Link Connector (DLC).