Part 1

Part I
Oil filter flange, disassembling
=> Refer to Lubrication system components, removing and installing.

1- Oil pump 12 bar (174 psi) pressure relief Before installing, ensure that both oil pump/cylinder head centering sleeves are in place Replace if running surfaces and/or gears are scored
2- Chain sprocket
3- 20 Nm (15 ft. lbs.)
4- Chain
5- Sealing flange
^ Removing and installing:
=> Refer to Sealing flange (front), removing and installing.
- Insert with silicone sealant
D 176 404 A2
^ Crankshaft oil seal (pulley side), replacing
=> Refer to Crankshaft oil seal (pulley end), replacing.
6- 15 Nm (11 ft. lbs.)
7- Chain tensioner
(with tensioning rail)
^ 15 Nm (11 ft. lbs.)
- When installing, pretension spring and then install
8- Dipstick
^ Oil level must NOT be above the Max. mark!
^ Marks: => Refer to Lubrication system components, removing and installing.
9- Guide
- Remove to draw oil out
10- Guide tube
11- Dowel sleeves
12- O-ring
Replace
13- Suction pipe
- Clean strainer
14- Baffle plate
15- Oil pan
- Clean sealing surface before installing
- Install with silicone sealant
D 176 404 A2 => Refer to Oil pan, removing and installing.
16- Seal
- Replace
17- Oil pan drain plug
^ 30 Nm (22 ft. lbs.)