Rear Door Panel: Service and Repair

Rear Door Trim, Removing And Installing

Removing
- Switch ignition off.







NOTE: Place scraping blade - 2 - or similar tool between screwdriver and door trim to avoid damage on door trim.

- Insert screwdriver (max. 5 mm wide) into hole on underside of inside door handle - arrow -, rotate and pry out panel - 1 -.







- Remove bolts - 1 - and - 2 -.

NOTE: Inside door handle - 3 - is bolted to door trim and can only be removed when door trim is removed.







- Remove bolt - 1 -.
- Unclip door trim at the sides using Pliers 3392.
- Lift door trim upward out of window recess.







- Pull cable - 1 - out of guide - 2 - in direction of arrow and disengage.
- Disconnect harness connector - 3 -.

Installing







- Pull off window recess seal - 1 - from door trim and insert in window recess.

NOTE: Replace clips before installing door trim.