I - ATF Pump to Support Tube

I - ATF pump to supporting tube, removing and installing

Overview; General Information
Disassembling transmission; Transmission, Disassembling
Assembling; Transmission, Assembling





1. Bolt
^ Qty. 7
^ Tighten to 8 Nm (71 inch lbs.) and turn 90° further
^ Turning 90° further may be done in several stages
2. ATF pump with -B2- piston
^ Disassembling and assembling; Fluid Pump
3. O-ring
^ Always replace
^ Place on ATF pump
4. Gasket
^ Always replace
5. Retaining ring
^ Not installed on transmissions: DFL, DFM, DFG, DFH, DFK.
6. Shim
^ Not installed on transmissions: DFL, DFM, DFG, DFH, DFK.
7. Spring cap, laity. 6
^ Install 3 spring caps after installing first outer plate
^ Install 3 spring caps before installing last outer plate
8. Spring
^ Qty. 3
9. Spring washer
^ Only installed on transmissions: DFL, DFM, DFG, DFH, DFK.
10. Outer plate -B2-
^ Always install 2 mm (0.07 inch) thick outer plates
^ Quantity; Specifications
11. Inner plate -B2-
^ Quantity; Specifications
^ Before installing, place new inner plates in ATF for 15 minutes
12. Outer plate -B2-
^ Always install 2 mm (0.07 inch) thick outer plates
^ Quantity; Specifications
13. Outer plate -B2-
^ Install 3 mm (27 inch) thick outer plate to supporting tube
14. Supporting tube -B2-
^ For-B2- plate package
^ Insert so groove engages in wedge of free gear
^ Application as a replacement part according to transmission code letters
15. Transmission housing with clutches installed