Sunroof With Glass Panel, Assembly Overview

Sunroof With Glass Panel, Assembly Overview







1 - Glass panel for sunroof (one-piece safety glass)
2 - Panel seal
- Seal joint at center in rear area.
- Replacing panel seal.

3 - Sun protection
4 - Countersunk screws
- Qty 4
- 1.8 Nm
- Screws are microencapsulated and must always be replaced after removing.

5 - Slider
6 - Upper trim
- Up to CW35/02

7 - Lower trim
- Up to CW35/02

8 - Water channel
- Removed together with slotted guide rail

9 - Guide locking hook
10 - End piece
- Use butyl adhesive sealing cord AKL 450 005 05 for sealing.

11 - Installation unit
- If necessary use special grease G 000 450 02 exclusively to grease guide channels, otherwise functions cannot be guaranteed.

12 - Bolt
- Qty. 3
- 3.5 Nm
- Screws are microencapsulated and must always be replaced after removing.

13 - Hex wrench for emergency operation
- Clipped in on E-drive motor cover.

14 - Electrical drive motor
- Adjusting drive motor (0 position).

15 - Spring
16 - Wind deflector
17 - Torx screw
- Torx key T25
- 4.5 Nm

18 - Rear guide
- Removed together with slotted guide rail

19 - Slotted guide rail
20 - Gap bracket
- Removed together with slotted guide rail

21 - Boots
- As of CW36/02

NOTE: Boots and trim must not be replaced against each or, otherwise, clearance for mechanical components is not guaranteed.