Rear Seat Cover and Cushion For Seatbench, Removing and Installing

Rear Seat Cover And Cushion For Seatbench, Removing And Installing







1 - Cover
- Removing:
- Cut through cushion clamps, release tension on tension wire, pull cover over wire frame, unhook cushion wire using awl V.A.G 1636 from cushion, also cut through any cushion clamps and remove cover.

2 - Cushion wire
- Hooked into cushion, unhook and hook using awl V.A.G 1636

3 - Cushion
4 - Cushion clip
- Cut through to remove (will be destroyed)
- To install, replace with new and compress using cushion pliers V.A.G 1634

5 - Wire frame
6 - Cushion clips
- Cut through to remove (will be destroyed)
- To install, replace with new and compress using cushion pliers V.A.G 1634

7 - Tension wire