Clutch Release Bearing: Service and Repair

5 Speed Manual 02J





Clutch Release Mechanism, Servicing
1. Transmission
2. Ball stud, 25 Nm (18 ft. lbs.)
- Lubricate with MOS2 grease
3. Input shaft oil seal
- Replacing refer to Manual Transmission/Transaxle; Input Shaft.
4. Guide sleeve
- With vulcanized C-ring
- If damaged replace guide sleeve and O-ring together
- Lubricate guide sleeve in area of release bearing with MOS2 grease
5. Retaining spring
- Secure to clutch release lever
6. Securing bolt, 20 Nm (15 ft. lbs.)
7. Clutch release lever
8. Release bearing
- Do not wash with solvents, only wipe off
- Replace noisy bearings
- Lubricate surfaces which contact release lever with MOS2 grease
9. Bolt, 20 Nm (15 ft. lbs.)
10. Slave cylinder
- Removing and installing. Refer to Clutch Master Cylinder.
11. Plunger
- Grease end of plunger with MOS2 grease
12. Assembly bolt
- Secures the clutch release lever when installing transmission
- Remove after transmission has been installed

Note:
- If the assembly bolt (item -12-) is not available, an M8 x 35 bolt can be used.