Engine: Locations

Engine Disassembly and Assembly Notes






Note:

- If during engine repairs, metal shavings or large quantities of small metal particles caused, for example, by partial seizure of crankshaft and conrod bearings - are found in the engine oil: To prevent consequential damage, besides thoroughly cleaning out the oil passages, you must also replace the oil cooler.

Part I






1. 45 Nm (33 ft. lbs.)
2. Engine support
3. 25 Nm (18 ft. lbs.)
4. Bracket
5. Bolt, 10 Nm (7 ft. lbs.)
6. 20 Nm (15 ft. lbs.)
7. Camshaft drive belt guard, upper section
8. Camshaft drive belt guard, center section
9. Washer
10. Tensioner
11. Camshaft drive belt
12. Camshaft drive belt guard, rear
13. O-ring
14. Coolant pump
15. 15 Nm (11 ft. lbs.)
16. Camshaft drive belt sprocket (crankshaft)
17. 90 Nm (66 ft. lbs.) + 1/4 turn (90°)
18. Camshaft drive belt guard -lower part
19. 10 Nm (7 ft. lbs.)
20. Pulley
21. Pulley
22. Ribbed belt
23. Belt - pulley/vibration damper
24. 40 Nm (30 ft. lbs.)
25. Ribbed belt tensioner

Part II






1. Engine block
2. Knock sensor 1 -G61
3. 2-pin harness connector
4. 20 Nm (15 ft. lbs.)
5. 2-pin harness connector
6. Knock sensor 2 -G66
7. Oil dipstick tube
8. Dipstick
9. Coolant pipe
10. 40 Nm (30 ft. lbs.)
11. Bracket
12. Bracket
13. 10 Nm (7 ft. lbs.)
14. Oil filter bracket
15. 15 Nm (1 1 ft. lbs.) + 1/4 turn (90°)
16. Seal
17. Gasket
18. Engine speed sensor
19. Sealing ring
20. 25 Nm (18 ft. lbs.)
21. O-ring
22. Oil filter
23. Oil cooler
24. Connection
25. 15 Nm (11 ft. lbs.)
26. Coolant thermostat
27. 45 Nm (33 ft. lbs.)
28. Assembly bracket