Headlamp: Locations

Headlights (Jetta), Assembly


CAUTION!

Before beginning repairs on the electrical system:
- Obtain the anti-theft radio security code.
- Switch off all electrical consumers.
- Switch the ignition off and remove ignition key.
- Disconnect negative (-) battery terminal.
- When disconnecting and reconnecting battery terminals, observe all applicable notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks.


NOTE:

- After performing any repairs or service that could affect headlight aim, check/adjust aim.






1 - Sealing cap
2 - Sealing cap
3 - Double filament bulb for low and high beams
Bulb H4, 12 V, 60 W/55 W
4 - Headlight beam adjusting motor*
5 - Not applicable to USA/CDN
6 - Not applicable to USA/CDN
7 - Headlight housing
8 - Fog light bulb
Bulb H3, 12 V, 55 W
9 - Double filament bulb for parking/turn signal light
Bulb 12 V, 21W/SW
10 - Parking/turn- signal light bulb holder

*) Where applicable