Fuel Delivery and Air Induction: Locations

Diesel Injection System, Component Locations

Components A, B and C are not shown on the illustration.






A Brake vacuum vent valve switch for cruise control/diesel fuel injection -F47- and Brake light switch -F63-
Together in one housing in footwell on brake pedal

B Throttle Position (TP) Sensor -G79-
In footwell on throttle pedal
In case of malfunction it is displayed as Throttle Position sensor -G69-

C Clutch vacuum vent valve switch -F36-
in footwell on clutch pedal

1. EGR valve
2. Change over valve for intake manifold flap -N239-
3. Needle Lift Sensor -G80-
4. EGR vacuum regulator solenoid valve -N18-

5. Diesel Direct Fuel Injection (DFI) Engine Control Module (ECM) -J248-
with Barometric Pressure (BARO) sensor -F96-
tighten nut for ground wire (located forward of ECM) to 9 ±1 Nm (80 ±9 in. lb)

6. Wastegate bypass regulator valve -N75-
7. Mass Air Flow (MAF) Sensor -G70-
8. Engine - Coolant Temperature (ECT) Sensor -G62-
9. Engine speed (RPM) sensor -G28-

10. Harness connector
for Needle lift sensor -G80-

11. Harness connector
for Engine Speed sensor -G28-
for Cold Start injector -N108-

12. Harness connector
for Fuel temperature sensor -G81-
for Quantity adjuster -N146-
for Modulating piston displacement sensor -G149-
for Fuel shut-off valve -N109-

13. Cold start injector -N108-
14. Fuel shutoff valve -N109-

15. Injection pump Quantity adjuster -N146-
with Fuel temperature sensor
with Quantity adjuster -N146-
with Modulating piston displacement sensor -G149-

16. Manifold Absolute Pressure (MAP) sensor -G71- and Intake Air Temperature (IAT) sensor -G72-