Gear Lever Housing, Servicing

5 Speed Manual 02J

Gear lever housing, servicing






1 - Gear lever knob.
- Screw on and off together with cover.
2 - Boot with frame.
- Remove and install together with gear lever knob.
- Separating from gear lever knob see Fig.1.
- Connect to gear lever knob before installing see Fig.1.
3 - Bushing.
4 - Clamp.
- To secure gear lever knob on gear lever.
5 - Bushing.
- Clipped into rubber noise damper.
6 - Rubber noise damper.
- Installation position: Arrows point toward front of vehicle.
7 - Cover.
8 - Hex nut, 25 Nm.
9 - Floor plate.
10 - Retainer.
- For gear lever housing.
11 - Gasket.
- Between gear lever housing and floor.
- Self-adhesive.
- Bond to gear lever housing.
12 - Gasket.
- Between selector cables and gear lever housing.
13 - Gear lever housing.
14 - Gasket.
- Self-adhesive.
- Bond underneath gear lever housing.
15 - Cover plate.
16 - Hex combi bolt, 25 Nm.

Fig. I Separating cover from gear lever knob and assembling to gear lever knob






- Turn cover inside out.
- With a screwdriver carefully pry segment in direction of arrow and simultaneously pull gear lever knob out.

Installation is carried out in the reverse sequence, when doing this note the following:

- Insert gear lever knob in cover.
- Push sleeve onto gear lever knob and engage.
- Install gear lever knob and cover together.