Lock Cylinder Carrier, Removing and Installing (Power)

Removing
- Remove trunk lid trim refer to "Lock Carrier Trim, Removing and Installing". Service and Repair





- Separate connectors -arrows-.
- Unclip operating rod -2- for lock carrier.
- Release wire from clip -2-





- Remove screws -1- and remove electrical wire support panel -2-.





- Remove bolts -1- and loosen tie wrap -3- of water drain channel -4-.
- Pull lock cylinder carrier -1- off trunk lid and then from outer hand grip.

Installing
- Reassemble in reverse sequence.
- Replace tie wrap for water drain channel and clips to fasten wire harness.