Operation CHARM: Car repair manuals for everyone.

Rear Brakes







Disc Brakes

1. Screw
^ 4 Nm (35 inch lbs.)

2. Brake disc
^ Thickness: 9 mm (0.354 inch)
^ Wear limit: 7 mm (0.275 inch)
^ When worn, always replace on both sides.

3. Cap
^ Removing and installing, Refer to Transmission and Drivetrain.

4. Self-locking nut
^ 175 Nm (129 ft. lbs.)
^ Always replace after removing

5. Wheel hub with wheel bearing and rotor
^ Always replace after removing
^ Only replace as complete unit
^ Removing and installing, Refer to Transmission and Drivetrain.

6. Bolt
^ 60 Nm (44 ft. lbs.)
^ With dished spring washer

7. Splash shield
8. Stub axle
9. Parking brake cable
^ Adjusting parking brake. Adjustments

10. Axle beam
11. ABS wheel speed sensor
^ Before inserting sensor, clean installation hole inner surface and coat with grease, Part No. G 000 650

12. Socket-head bolt
^ 8 Nm (71 inch lbs.)

13. Socket-head bolt
^ 65 Nm (48 ft. lbs.)

14. Brake carrier with guide pins and protective cap
^ Supplied as replacement part assembled with sufficient grease on guide pins
^ If protective caps or guide pins are damaged use repair kit. Use grease packet supplied to lubricate guide pins.

15. Brake hose/line
^ With banjo bolt and seals
^ Banjo bolt to brake caliper tightening torque: 35 Nm (26 ft. lbs.)
^ Do not disconnect brake hose when changing brake pads

16. Self-locking bolt
^ 35 Nm (26 ft. lbs.)
^ Always replace

17. Brake caliper
^ Servicing. Rear Brake
^ Adjust parking brake cable after maintenance or replacement.
^ Do not pull parking brake before adjusting it! Adjustments

18. Brake pads
^ Thickness: 14 mm (0.551 inch)
^ Checking thickness, Refer to; Maintenance
^ Always replace brake pads on same axle on both sides of vehicle
^ Removing and Installing

19. Pad retaining springs Always replace springs when changing pads