Vehicle Damage Warnings

To prevent injuries to persons and/or damage to the fuel injection and ignition system, note the following:
- Do not touch or disconnect ignition wiring when the engine is running or being turned at starter speed.
- Switch OFF the ignition before connecting or disconnecting injection or ignition system wiring or test cables.

If engine must be turned at starter speed, without starting the engine







- Disconnect 5-pin harness connector -1- from ignition coil Power output stage -2-.







- Remove fuse 28 (for fuel Pump)

Observe following points if Test and measuring instruments are required during a test drive!

- Attach all Test and measuring instruments to the rear seat and operate them from that location using a 2nd technician.
- If test and measuring instruments are operated from front passenger's seat and the vehicle is involved in an accident, there is a possibility that the person sitting in this seat may receive serious injuries if the airbag is triggered.