Part I

Part I
1. 25 Nm
2. Tensioning device for ribbed belt
^ Turn with open-end wrench to loosen ribbed belt, Refer to Drive Belts, Mounts, Brackets and Accessories.
3. 20 Nm
4. Toothed belt guard - upper part
5. 10 Nm
6. 10 Nm
7. Tensioning roller
8. Toothed belt
^ Mark direction of rotation before removing
^ Check for wear
^ Do not kink
^ Removing, installing and tensioning, Refer to Timing Components.
9. 20 Nm
10. Rear toothed belt guard
11. Intermediate shaft sprocket
12. 80 Nm
13. Idler wheel
14. Tensioner for toothed belt
15. Crankshaft toothed belt sprocket
16. 10 Nm
17. 9O Nm + 1/4 turn (90°) further
^ Always replace
^ Oil threads
^ Counter-hold with 3099 to loosen and tighten
^ The quarter turn further can be done in several stages.
18. 25 Nm
19. Toothed belt guard - lower part
20. 10 Nm
21. Pulley
^ For viscous fan coupling
22. Pulley
^ For power assisted steering pump
23. V-belt
^ Removing and Installing, Refer to Drive Belts, Mounts, Brackets and Accessories; Water Pump.
24. Pulley
^ V-belt version
25. 25 Nm
26. Pulley
^ For coolant pump
^ V-belt version
27. Belt pulley/vibration damper
^ Can only be installed in one position. Holes are offset
^ Note position when installing toothed belt, Refer to Timing Components.
28. Ribbed belt
^ Mark direction of rotation before removing
^ Removing and installing