Rear Bumper: Locations

1 - Bumper cover
- Material: PP/EPDM
- Removing:
- Loosen hamper cover at wheel liner.
- Remove bolts -13- .Pull cover off guides -8- (left and right).
2 - Bumper trim
- Clipped into cover
3 - Bumper beam
4 - Bolt
- Qty. 2
- 15 Nm (11 ft lb)
5 - Bolt
- Qty. 4
- 30 Nm (22 ft lb) + 1/2 turn(180°)
6 - Speed nut
7 - Bolt
- Qty. 6
- 2 Nm (18 in.lb)
8 - Guide
- To remove/install bumper, pull or push parallel on guides on left and right.
9 - Spreader nut
- Qty.6
10 - Securing strip
11 - Bolt
- Qty. 4
- 1.2 Nm (10-14 in. lb)
12 - Impact damper
13 - Bolt
- Qty. 5
- 6 Nm (53 in. lb)