Rear Backrest (One Piece), Removing and Installing

Rear Backrest (One Piece), Removing And Installing

Removing
- Remove seatbench.
- Remove headrests.







- Press down upholstery in area of headrest guides and disengage locking mechanisms in direction of travel - arrow A -.
- Remove headrest guides upward.
- Fold out center armrest, press locking mechanisms - 1 - and - 2 - toward outside and remove frame - 3 -.
- Remove bolt - 4 - (23 Nm).

Only for vehicles with center three-point seatbelt







- Remove bolt - 1 - (40 Nm) and remove belt end fitting from seatbelt - 2 -.
- Unclip cover - 3 - and belt guide - 4 -.

NOTE: When installing, make sure that headrest guides are installed previous to belt guide - 4 - and cover - 3 -.

All models







- Remove rear backrest in area of outer headrests from locking devices.
- Remove backrest upward out of side locking mechanisms in area of sill panel.

Installing
Installation is performed in the reverse order of removal.

NOTE: Before installing seatbench, mountings - 1 - must be replaced.