Accelerator Pedal Position Sensor: Service and Repair

Accelerator Mechanism, Servicing

Engine code AEB only







1 - Throttle cable mounting
- On bulkhead in plenum chamber
2 - Throttle cable mounting
- On bulkhead
- Only vehicles with manual transmission
3 - Retaining clip
- Only vehicles with manual transmission
- Ensure seated securely
- Secured behind bulkhead
4 - Retaining clip
- Only vehicles with automatic transmission
- Ensure seated securely
- Secured before bulkhead
5 - Kickdown switch -F8-
- On bulkhead
6 - Connector
- Black, 2-pin
7 - Accelerator cable
- Do not reuse damaged accelerator cable, replace
8 - Cable cam
- On throttle valve control part
9 - 10 Nm
10 - Support bracket
- For accelerator cable
11 - Retainer
12 - Accelerator pedal
13 - Mounting bracket
14 - Accelerator pedal stop







Fig. 1 Removing and installing throttle cable mounting

Removing
- Turn throttle cable mounting approx. 90° a counter-clockwise and remove from bulkhead in plenum chamber.

Installing
- Push throttle cable through bulkhead in plenum chamber (arrow 1).
- Push throttle cable mounting into bulkhead and turn approx. 90° clockwise (arrow 2).







Fig. 2 Installation position of accelerator pedal stop on mounting bracket
- Letters "HS" -1- are visible when installed in vehicles with a manual transmission.
- Letters "AG" -2- are visible when installed in vehicles with automatic transmission.