Input Shaft Bearing and Multi-Function Switch

Input shaft bearing and multi-function switch, disassembly and assembly





1. Transmission housing
^ Removing and installing differential and shaft flanges. Refer to Differential.
^ Replacing speedometer vehicle speed sensor and drive gear. Refer to Speedometer Gear.
^ Breather installation position Fig. 1
2. Tory socket head bolt
^ 35 Nm (26 ft. lbs.)
^ Self-locking
^ Always replace
3. Guide sleeve
4. Dished washer
^ Smaller diameter (convex side) faces guide sleeve
5. Circlip
^ Determining thickness. Refer to Input Shaft; Adjustments.
6. Ball bearing
^ Removing and installing.
7. Circlip
^ Determining thickness. Refer to Input Shaft.
8. Input shaft
^ Removing and installing.
^ Disassembling and assembling.
^ Adjusting.
^ Servicing input shaft bearings.
9. Bolt
^ 25 Nm (18 ft. lbs.)
10. Locking plate
^ For multi-function switch
11. Multi-function switch
12. Multi-function switch connector
13. 10 Nm (7 ft. lbs.)
14. Shift rod cover
^ Removing and installing.
15. 5th and reverse gear detent
^ Removing, installing and checking.





Fig. 1 Breather installation position
After pressing in, the breather must project 21 mm (0.827 inch) out of housing.