Shift Cable: Adjustments

Selector Lever Cable, Checking And Adjusting

Checking:
- Shift selector lever into "P".
- Remove selector cable retaining clip -3- at support Transmission.





- Pry selector lever cable -1- off lever/selector shaft -4- and route so that the end is free to move.

Note:
^ Do not bend or kink selector lever cable.

- Move selector lever from "P" to " 1 ".
- Check protective boot for damage; protective boot can only be changed together with selector lever cable.
- Move selector lever to "P".
^ Selector lever mechanism and selector lever cable must move freely. If necessary replace selector lever cable or check selector lever mechanism.
- Selector lever cable, removing and installing. Refer to Service and Repair. Service and Repair

Adjusting





- Shift selector lever into "P".
- Shift selector lever/shaft -4- to "P". Parking lock should engage and it should not be possible to turn front wheels in same direction.
- Loosen bolt -2- at selector lever cable front ball mount -1-.
- Tighten bolt -2- 8 Nm (71 inch lbs.).