Servicing Hydraulic System

Hydraulic System, Assembly Overview
1. Brake fluid reservoir
2. Supply hose
3. Master cylinder
^ Removing and installing.
4. Retainer
^ Replace only with master cylinder removed
^ Removing refer to Fig. 1
^ Pressing on refer to Fig. 2
5. Clutch pedal
^ Removing and installing.
6. Self-locking hexagon nut, 25 Nm (18 ft. lbs.)
^ Always replace
7. O-ring
^ Lubricate with brake fluid
^ Pull onto line/hose connection
8. Line/hose assembly
9. Bracket
^ Secured to body work
10. Dust cap
11. Bleeder valve
^ Bleeding clutch system.
12. Slave cylinder
Remove the following components before removing slave cylinder
^ Gear selector cable from gear selector lever.
^ Relay lever and actuating arm for gate selector cable.
After installing:
- Adjust gear selector mechanism.
13. Bolt, 25 Nm (18 ft. lbs.)
14. Transmission
15. Clip
16. O-ring
^ Lubricate with brake fluid
^ Pull onto line/hose connection
17. Cable support bracket
18. Hose bracket Secure to control cable support bracket
19. Clip





Fig. 1 Pry retainer -A- off in direction of arrow





Fig. 2 Press master cylinder operating rod into retainer -A- in direction of arrow