Selector Mechanism Disassembling and Assembling

Selector mechanism, disassembling and assembling

Note: Lubricate mounting points and contact surfaces with grease, Part No. G 052 142 A2.





1. Selector lever handle
- Removing and installing
2. Sleeve
- Locates in selector lever handle
- Prevents selector lever handle from being pulled off
3. Cover
- With symbol Page l
- Clipped into frame -item 5
4. Printed circuit
- Can be checked in electrical test and in measured value block
5. Frame
6. Cable clip
- Clipped into frame -item 5
7. Bracket
- For selector lever cable
- Fitted on front tunnel heat shield
8. Locking plate
- Secures selector lever cable to mounting bracket
- Always replace
9. Selector lever cable
- Do not bend or kink
- If outer cable is damaged the selector lever cable must be replaced
- Checking and adjusting
- Removing and installing
- Do not grease cable eye and ball socket
10. Collared nut, 10 Nm.
- For cover to mounting bracket
- Qty. 4
- Self-locking
- Always replace
11. Cover
- For mounting bracket
- With bonded seal
12. Hex bolt
13. Locking pawl
- For selector lever lock
- Grips into cable lever of mounting bracket
14. Shift lock solenoid -N110
- Can be replaced with selector mechanism installed
- Removing and installing
- Can be checked in electrical test and in measured value block
15. Mounting bracket
- Removing and installing
16. Locking cable
- For ignition key removal lock
- Must not be kinked
- Removing and installing
- Adjusting
- Checking operation of the ignition key withdrawal lock.
17. Steering lock
18. Clip
- Position: push on clip from above. The angled ends of clip face steering lock.