Operation CHARM: Car repair manuals for everyone.

Timing Belt: Diagrams





1- 45 Nm (33 ft lb)

2- Engine support

3- 25 Nm (18 ft lb)

4- Bracket
Attached to lower pan of in- take manifold

5- 20 Nm (15 ft lb)

6- Camshaft drive belt guard,upper section

7- Camshaft drive belt guard,center section

8- Washer

9- Tensioner
Semi-automatic camshaft drive belt tensioning roller checking. Procedures

10- Camshaft drive belt
- Mark engine direction of rotation before removing
- Check for wear
- Do not kink
Removing, installing and tensioning Procedures

11- Camshaft drive belt guard, rear

12- 0-ring
- Always replace

13- Coolant pump
- Check for free turning
- Replace as an assembly if leaking or binding

14- 15 Nm (11 ft lb)

15- Camshaft drive belt sprocket (crankshaft)

16- 90 Nm (66 ft lb) + 1/4 turn (90°)
Always replace
Threads and shoulder must be free of oil and grease
Counter-hold with 3415 to loosen and tighten
90° additional angle can be measured with torque angle meter i.e.., Hazet 6690

17- Camshaft drive belt guard - lower part

18- 10 Nm (7 ft lb)
- Always replace

19- Pulley
for A/C compressor

20- Pulley
for power steering pump

21- Ribbed belt
- Mark direction of rotation before removing
- Check for wear
- Do not kink

22- Belt pulley/vibration damper
Can only be installed in one position, holes are off-set
Note position when installing toothed belt Procedures

23- 40 Nm (30 ft lb)

24- Ribbed belt tensioner
- Slacken ribbed belt by turning with open-end wrench