Campaign Work Procedure

Parts





Special Tools and Equipment

Work Sequence

Section A - Emergency Li9ht Switch Replacement

^ Switch off all electrical consumers and remove key from ignition switch.





^ Emergency light switch -3- is the center switch in the instrument panel.

^ To remove emergency light switch, the ESP or ASR switch -2- must be removed, and to remove the ESP or ASR switch, the seat heater switch - 1 - must be removed.

^ If an ESP or ASR switch -2- is located next to the emergency light switch, go to Section B; otherwise, continue.





^ If there is no ESP or ASR switch and only a blank cover -2-, apply adhesive tape to instrument panel under cover, use a flat screw driver -A- to remove cover.

^ Insert assembly tool T10034 into opening, release clip holding emergency light switch -3- and pull it out of instrument panel.

^ Disconnect connector from emergency light switch.

^ On new emergency light switch (1J0 953 235 J 01C) reconnect connector and install switch into instrument panel.

^ Reinstall blank cover and remove adhesive tape.

^ Check turn signal and emergency light switch for correct operation.

^ Check all turn signal and emergency light switch bulbs for illumination and replace as required.

^ Destroy and properly dispose of removed part(s).

Section B - Emergency Light Switch Replacement on Vehicles with ESP or ASR





- Apply adhesive tape to the instrument panel under seat heater switch -1- or the blank cover if the vehicle does not have heated seats and using a flat screw driver -A-, remove the seat heater switch or cover.

- Insert assembly tool T10034 into seat heater switch opening, release the clip holding the ESP or ASR switch -2- and pull it out of instrument panel

^ Insert assembly tool T10034 into ESP or ASR switch opening, release the clip holding the emergency light switch -3- and pull it out of instrument panel.

^ Disconnect connector from the emergency light switch

^ On new emergency light switch (1J0 953 235 J 01C) reconnect connector and install switch into instrument panel

^ Reinstall ESP or ASR switch and seat heater switch into in the instrument panel and remove adhesive tape

^ Check turn signal and emergency light switch for correct operation

^ Check all turn signal and emergency light switch bulbs for illumination and replace as required

^ Destroy and properly dispose of removed part(s)