Instrument Cluster Senders and Sensors Locations

CAUTION!
Before carrying out any repair work on the vehicle electrical system the battery ground (GND) terminal must be disconnected.


NOTE: On vehicles with On Board Diagnostic II (OBD II) the readiness code for the engine control module must be regenerated after the battery is reconnected.

1 - Sender for fuel gauge -G-
- Location See Fig. 1
- Monitored by OBD
2 - Outside air temperature sensor -G17-
- Location See Fig. 2
- Monitored by OBD
3 - Speedometer Vehicle Speed Sensor (VSS) -G22-
- Location See Fig. 3
- Monitored by OBD
4 - Engine Coolant Temperature (ECT) sensor -G2-
- Location differs by engine type

- Monitored by OBD
5 - Instrument cluster -K-
- Monitored by OBD

Fig. 1 Location of sender for fuel gauge -G-







Sender is located inside the fuel tank at the fuel pump (arrow).

Fig. 2 Location of outside air temperature sensor -G17-







Sensor is located at left-front near bumper behind the outer ventilation grill.

To remove sensor, the ventilation grill can be unclipped.

Fig. 3 Location of speedometer Vehicle Speed Sensor (VSS) -G22-







Sender (arrow) is installed in the area of the left drive flange on manual and automatic transmissions.