Door, Removing and Installing

Door, Removing And Installing







- Remove lower A-pillar trim - 5 -.
- Disconnect connectors - 6 - at A-pillar.
- Remove boot - 3 - from A-pillar. Thread electrical wires out through opening - arrow - from pillar.
- Pry off cover cap - 2 - and remove bolt - 1 - from upper hinge pins. Tightening torque: 13 Nm
- Remove bolt - 4 - using Door adjusting wrench 3320 and Box spanner 3320/2 from hinge. Tightening torque: 20 Nm + 1/4 turn (90°) turn

NOTE: This bolt must always be replaced.

- Lift out door upward from angle hinge.