Right Backrest Lock (Two Pieces), Removing and Installing

Right Backrest Lock (two Pieces), Removing And Installing

Removing
- Remove backrest.
- Remove cushion.







- Press connecting rod ball joint - 1 - off catch - 2 - using screwdriver - arrow -.







- Remove circlip - 1 - from pin - 2 -.
- Remove spring - 3 - from backrest - 4 - using a screwdriver.







- Remove pin - 2 - from backrest - 4 -, hold spring - 3 - in place using pliers and remove while doing this.







- Disengage button housing - 1 - - arrow - and remove from rear panel - 3 -.
- Remove release rods - 2 - and clips - 4 - from rear panel - 3 -.

NOTE: Clips - 4 - can be removed from rear panel when spreader pins are pressed out of clips. (Remove spreader pins from rear panel for reinstallation.)

Installing
- Installation is performed in the reverse order of removal.







- Pin - 2 -, spring - 3 - and catch - 5 - must be inserted together.
- Engage circlip - 1 - on pin - 2 -.
- Tension spring - 3 -.
- Perform functional check when completely installed, readjust catch if necessary.

Adjusting catches







- If present, loosen nut - 3 - and press connecting rod ball joint - 1 - off catch - 2 - - arrow - using screwdriver.
- Turn ball joint - 1 - on operating rod so that effective length of connecting rod becomes larger or smaller.