Components In Passenger Compartment Servicing

Components in passenger Compartment, servicing

CAUTION!
- Before working on the electrical system, obtain radio security code and disconnect battery Ground (GND) strap.
- When reconnecting battery, always check operation of vehicle equipment such as radio, clock, and power windows.

NOTES:
- Before carrying out any work on the A/C refrigerant system refer to A/C refrigerant system safety measures. [1][2]Service Precautions

- System components identified with an * must only be serviced or replaced after discharging refrigerant system. Use Kent Moore ACR4 or equivalent.





1 - Heating and A/C controls
- With A/C switch -E35-
- With fresh air blower switch -E9-
- With switch for fresh air blower and recirculated air -E184-
- Removing and installing refer to "Control Assembly Removing and Installing/Heating and A/C Controls". Service and Repair
- Assembly refer to "Heating and A/C Controls, Assembly". Description and Operation

2 - Dust and pollen filter
- Removing and installing refer to "Dust and Pollen Filter, Removing and Installing". Service and Repair

3 - Side window air outlet
- Removing refer to "Air Outlets, Removing". Service and Repair

4 - Side air outlets
- Removing refer to "Air Outlets, Removing". Service and Repair

5 - Center air outlet console
- Removing refer to "Air Outlets, Removing". Service and Repair

6 - Instrument panel cross member
- Loosening and tightening see Fig. 2. Heating and Ventilation System, Servicing

7 - Servo motor for fresh/recirculating air door -V154-
- Removing and installing refer to "Heating and Ventilation Unit, Disassembly and Assembly". Procedures

8 - Fresh air blower -V2-
- Removing see Fig. 1 Heating and Ventilation System, Servicing

9 - Fresh air blower series resistance with fuse -N24-
- Removing see Fig. 1 Heating and Ventilation System, Servicing

10 - Intermediate duct

11 - Cables
- Installing and adjusting refer to "Control Cables, Installing and Adjusting/Heating and A/C Cables". Service and Repair

12 - Rear footwell duct

13 - Gasket

14 - Connecting duct
- With front footwell air outlet
- Removing Heating and Ventilation System, Servicing

15 - Heater/evaporator unit*
- Disassembly and assembly refer to "Heater/Evaporator Unit, Disassembly and Assembly". Procedures

16 - Heater core*
- Removing refer to "Heater/Evaporator Unit, Disassembly and Assembly". Procedures
- Always use new coolant after replacement

17 - Heater core/bulkhead seal
- Note reinstallation position see Fig. 2 in "Heating and Ventilation Unit, Disassembly and Assembly". Procedures

18 - Defroster duct
- Replacing:
- Remove instrument panel
See Instrument panel, removing and installing. Service and Repair
- Loosen instrument panel cross member see Fig. 2 Heating and Ventilation System, Servicing

19 - Instrument panel
- Removing and installing
See Instrument panel, removing and installing. Service and Repair

20 - Center air outlet duct

21 - Defroster air outlet panel
- Removing refer to "Defroster Air Outlet Panel, Removing". Service and Repair