Oil Pump, Crankcase Breather and Oil Spray Jets,

Oil pump, crankcase breather and oil spray jets, removing and installing

Removing and installing oil pan, oil filter and oil cooler Oil Pan, Oil Filter and Oil Cooler
Removing and installing chain driven type oil pumps Chain Driven Oil Pump, Removing and Installing






1. Oil pump
Only replace complete

2. Spray jet valve, 40 Nm

3. O-ring
Always replace

4. 45 Nm
5. Idler roller
6. 10 Nm
7. 10 Nm
8. Breather housing

9. Gasket/breather - plate
Always replace

10. Oil check valve, 25 Nm

11. Connector
12. 15 Nm

13. Oil distribution pipe
For oil spray jets for piston cooling

14. Cylinder block

15. 10 Nm
Insert with locking fluid "D6"

16. Oil spray jet
For piston cooling

17. Gasket
Metal
Always replace

18. Oil temperature sender -G8-, 10 Nm
For oil temperature gauge
White
If sealing ring is leaking nip open and replace.

19. Oil seal
Replacing
If a PTFE (teflon) seal was used, it must be replaced only with another PTFE seal
Install PTFE seals without oil or grease

20. Tensioning element
Secure before removing, refer to Removing Toothed Belt Procedures

21. 10 Nm
Insert with locking fluid "D6"

22. O-ring
23. Washer
24. Bearing bushing
25. 25 Nm
26. Tensioning lever