DTC Memory, Erasing and Ending Output

Requirements
- DTC memory has been checked

Erasing DTC memory
- Press => button.





Indicated on display-, (Clear for function selection)
- Press buttons -0- and -5- to select "Erase DTC memory" function 05.





Indicated on display
- Press -0- button to confirm input.





Indicated on display
- Press => button.





Indicated on display; (Clear for function selection)

Note:





If "DTC memory is not interrogated" is displayed, the OBD test sequence is faulty
- Follow the program sequence exactly: First check DTC memory, then erase.

Ending output
- Press buttons -0- and -6- to select "End Output" function 06.





Indicated on display
- Press -Q- button to confirm input.





Indicated on display
- Switch ignition off.
- Disconnect VAG 1551 scan tool.
- Switch ignition on.
- ABS warning light -K47- and warning light for brake system -K118- must go out after approximately 2 seconds.
- Test drive vehicle and attain a minimum of 60 km/h (approximately 37 mph) for at least 30 seconds.