With Manufacturer Scan Tool

Erase DTC Memory


NOTE: The vehicle system tester VAG 1552 can be used instead of the VAG 1551 Scan Tool, however a printout is not possible.


- Connecting Scan Tool. Scan Tool Connecting and Initial Checks
- Initiating On Board Diagnostic (OBD). Scan Tool Connecting and Initial Checks

Test requirements:
- DTCs are rectified
- Functional check has been carried out
- DTC memory checked again

Indicated on display


Rapid data transfer HELP
Select function XX


- Press keys -0- and -5- (the function "Erase DTC Memory" is entered with 05).

Indicated on display


Rapid data transfer Q
05 - Erase DTC Memory


- Confirm with -Q- key.

Indicated on display


Rapid data transfer ->
DTC Memory is erased!


- Press -> key.

Indicated on display


Rapid data transfer HELP
Select function XX


NOTE:
- If this appears in the display, the test sequence is inoperative.


WARNING!
DTC Memory was not checked


- Adhere strictly to test sequence; first check DTC memory, then erase memory.


- Press keys -0- and -6- to end the output.

Indicated on display


Rapid data transfer Q
06 - End output


- Confirm with -Q- key.

Indicated on display


Rapid data transfer HELP
Enter address word XX


- Switch off ignition.
- Disconnect connector to VAG 1551 Scan Tool.