Rear Disc Brakes, Servicing

Rear brakes (self adjusting)
1 Self-locking hex bolt
- 30 Nm (22 ft. lbs.)
- Always replace
- When loosening and tightening counter hold on guide pin
2 Brake pads
- Always replace in pairs
- Removing and Installing. refer to Brake Pads; Service and Repair
- Thickness: 11 mm (0.43 inch)
- Checking thickness. refer to Check Pad Thickness
- Brake pad wear limit: 2 mm (0.078 inch)
3 Ribbed combination bolt
- 95 Nm (70 ft. lbs.)
4 Brake carrier with guide pins and protective cap
- Supplied as replacement part assembled with guide pins greased
- If protective caps or guide pins are damaged use repair kit. Lubricate guide pins with supplied grease.
5 Ribbed combination bolt
- 95 Nm (70 ft. lbs.)
6 Brake disc
- Always replace in pairs
- Remove brake caliper prior to removing
- Brake disc diameter 345 mm (9.64 inch diameter)
- Brake disc thickness: 10 mm (0.393 inch) both sides
- Wear limit: 8 mm (0.314 inch)
7 Brake caliper housing
- Do not disconnect brake hose when changing brake pads