01N Automatic Transmission

Shift Lock Cable, Removing And Installing

Removing





- Move selector lever to position "1"
- Obtain radio code.
- Disconnect ground (GND) strap on battery.
- Remove selector lever handle. Shifter A/T
- Remove center console and extension.
- Remove steering wheel with airbag.
- Remove steering column switch.
- Remove steering column trim
- Turn ignition key to "ignition on" position.
- Move selector lever to Park position ups.
- Lift locking clip on locking device -1- and pull locking cable out from ignition/starter switch.
- Remove cover with guide (selector lever mechanism). Shifter A/T
- Unclip locking cable from securing spring on mounting bracket, by lifting securing spring slightly.
- Release locking cable from cable tie -2- and take out.

Installing
- Route locking cable, kink free
- Turn ignition key to "ignition on" position.
- Connect locking cable to ignition/starter switch.
- Ensure that locking device -l- engages.
- Secure locking cable with cable tie -2-.
- Turn ignition/starter switch to lock position (ignition off).
- Move selector lever to position "P."
- Clip a locking cable into securing spring in mounting bracket.
- Hook locking cable support bracket -3- into selector mechanism and locking cable eye into lever (for locking cable).