With Manufacturer Scan Tool

Diagnostic Trouble Code (DTC) memory, checking (function 02)

NOTE:
DTCs stored in memory along with corresponding malfunction descriptions can only be displayed by initiating the On Board Diagnostic program and checking DTC memory (function 02).
- Input address word 19 "Gateway" and then press -> button until "Select function XX" is shown in display.

Indicated on display (select function):


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -2- to select function 02, "Check Diagnostic Trouble Code (DTC) memory" .

Indicated on display:


Rapid data transfer Q
02 - Check DTC memory


- Press -Q- button to confirm input.

The number of stored malfunctions appears in the display.


X DTC recognized! ->


The number of stored DTCs or "No DTC s recognized" appears in the display and are printed out one after another.
- When the last DTC has been displayed and printed out, rectify malfunctions as described in DTC table.

If "No DTC recognized" is displayed, the program will return to the initial position after pressing -> button.


No DTC recognized! ->


Indicated on display (select function):


Rapid data transfer HELP
Select function XX


If display not indicated as shown: See Scan tool operating instructions
- End output (function 06).
- Switch off ignition and disconnect Data Link Connector (DLC).


NOTE:
If DTCs were recognized, follow the sequence below:
1. Rectify malfunction.
2. Erase Diagnostic Trouble Code (DTC) memory (function 05).
3. Check Diagnostic Trouble Code (DTC) memory (function 02).