Rear Bumper: Locations

1 - Cover
- Material: PP/EPDM
- Removing:
- Loosen bumper cover at wheel house liner.
- Remove boils -13-. Pull cover off guides -8- (left and right).
2 - Bumper trim
- Clipped into cover
3 - Bumper beam
4 - Bolt
- Qty. 2
- 15 Nm (11 ft lb)
5 - Speed nut
6 - Bolt
- Qty. 4
- 30 Nm (22 ft lb) + 1/2 turn (180°) further
- Always replace bolt if loosened
7 - Bolt
- Qty. 6
- 2 Nm (18 in. lb)
8 - Guide
- To remove/install bumper, pull or push parallel to guides on left and right.
9 - Spreader nut
- Qty. 6
10 - Securing strip
11 - Bolt
- Qty. 4
- 1.2 Nm (10-14 in. lb)
12 - Impact absorber
13 - Bolt
- Qty. 5
- 6 Nm (53 in. lb)