Side Mounted Turn Signals

Side Mounted Turn Signals, Removing And Installing

Removing


CAUTION!
Removal of turn signal lense/housing is only possible in one direction. The side of the housing equipped with retainer clip is not obvious in it's installed position. Use care When removing to prevent damage to retainer clip or housing.







- Carefully push turn signal lense from retainer side -1- towards retainer clip - arrow 2- and pull out from opening in fender (if necessary, apply masking tape to fender to prevent paint damage)..
- Pull off rubber boot and disconnect electrical connector.
- Pull bulb (12V/5W) directly out of socket (do not turn).

Installing
- Replace bulb.
- Reconnect electrical connector and secure rubber boot.
- Insert (snap-in) turn signal into opening in fender.
- Check function of side turn signal (lamp).