Cable For Locking Backrest, Removing and Installing (2-Door)

Cable For Locking Backrest, Removing And Installing (2-door)

Removing
- Remove seat.
- Remove headrest guides.
- Remove backrest.
- Remove handle - 3 - and unclip cover - 1 -.
- Remove cover and cushion.
- Break off four small metal tabs for locking sleeve - 12 - and drive rest of locking sleeve - 12 - into transfer rod - 11 - using a drift.

NOTE: Clip -2- and locking sleeve - 12 - must always be replaced after each disassembly.

- Press locking lever - 5 - downward and pull out cable hook - 6 -.
- Unclip center cable guide - 8 - from backrest frame - 4 -.
- Pull transfer rod - 11 - far enough out of backrest frame so that lower cable guide - 10 - can be unclipped.







- Unhook cable hook - 9 - and pull cable - 7 - out of backrest frame - 4 -.







Installing
- Installation is reverse of removal.