Testing and Information System VAS 5051
Vehicle Diagnosis, Testing and Information System VAS 5051, connecting and selecting ABS control moduleAll functions, which could previously be performed with V.A.G 1551 can also be performed with the new tester VAS 5051 in the operating mode "Vehicle On Board Diagnostic":
Operating for Vehicle Diagnosis, Testing and Information System VAS 5051.
Special tools and equipment
VAS 5051 Vehicle Diagnosis, Testing and Information System
Note:
^ The ABS function is switched off in the control module during the On Board Diagnostic.
^ The DTC memory can be erased after successful checking and repair.
^ Pull cover -1- off in direction of arrow.
^ With ignition switched off, connect tester VAS 5051 to diagnosis connection using diagnosis cable VAS 5051/1 or VAS 5051/3.
Note:
^ In the functions 04 - Basic setting 108 Read Measured value block, the display zones will be listed from top to bottom.
^ If the display does not indicate as described in the work sequence:
Operating instructions for Vehicle Diagnosis, Testing and Information System VAS 5051.
Indicated on display
Select operating mode:
^ Press button on display for "Vehicle On Board Diagnostic" -arrow-.
Indicated on display
Select vehicle system:
^ Press "03 - Brake electronics" on display -arrow-.
Displayed is
^ The control module identification number.
e.g. (130 907 379 D)
Allocation of control module
Parts catalog
^ System designation (ABS 20 IE)
^ Data BUS present. (CAN)
Electrical Wiring Diagrams, Troubleshooting & Component Locations binder
^ Control module code (03504).
Coding control module
^ Workshop code
Operating instructions for Vehicle Diagnosis, Testing and Information System VAS 5051.
Indicated on display
Select diagnostic function:
At this point all diagnostic functions are available.
For further measures see repair procedures.