Parallel Movement, Adjusting (Rockwell)

Parallel Movement, Adjusting


NOTE: The parallel movement adjustment can only be done when the drive motor and glass panel are removed ("0" position).


- Remove drive motor.







The mark (arrow) on the rear of the guide upper section -1- must, on both sides, lie within the marks (dimension -a-) on the slotted guide rail -2-.

The slotted guide rail -2- must be located in the guide (cannot be moved by hand).

- Slide guide upper part -1- from front to rear centrally between marks.
- Install drive motor in this position ("0" position).
- Check "0" position.