Cylinder Block and Components

Cylinder Block and Components






1. Knock Sensor 1 -G61-
Checking

2. 20 Nm
Tightening torque affects function of Knock Sensor (KS)

3. Knock Sensor 2 -G66-
Checking

4. Oil dipstick

5. Inlet spout
For oil dipstick

6. O-ring
Replace

7. Coolant line
8. 20 Nm

9. Oil filter bracket
Disassembling and assembling refer to Oil Filter Housing Oil Filter Housing

10. 15 Nm plus an additional 90° (1/4 turn)

11. Oil cooler
Coat contact area to flange, outside the seal, with AMV 1 88 100 02
Ensure clearance to adjacent components

12. 25 Nm

13. Oil filter element
Loosen with strap wrench
Tighten by hand
Note instructions on filter when installing

14. Gasket
Replace

15. 10 Nm

16. Engine speed sender -G28-
Checking

17. Connecting piece
18. 15 Nm

19. O-Ring
Replace

20. Coolant thermostat
Removing and installing, refer to Coolant Thermostat Thermostat
Note installation position, refer to Coolant Thermostat Thermostat
Checking: heat-up thermostat in water
Opening commences approximately 86°C / 187°F
Opening lift min. 7 mm

21. 45 Nm

22. Compact bracket
For generator, air conditioning compressor and power steering pump

23. Right engine bracket